Sunday, June 5, 2016

Recycled Pallet Clock

A few months (around Christmas) I found a nice kit at a big store that essentially gives you the basic components to make your own clock.

Last week-end I got bored and while in between two projects I decided to tackle this.

I was again going for that rough look and didn't feel any shame using imperfect wood that also contained nail holes.

This was a single-pallet-board project where I cut a board in 4 pieces, and then took 1 piece and cut it at a 45 degree angle to make the under side boards.

The whole thing was sanded and finished with a crystal water-based finish.


No comments:

Post a Comment